I have set the Abort Timeout to 900 seconds (15 min). Often I start a new print during that time. I start the print by sending it from OrcaSlicer without touching the OctoPrint interface.
It happened to me already 4 times now AutomaticShutdown did shutdown in the middle of such a second print, ruining the print.
It seems to me AutomaticShutdown is not correctly noticing a new print has been started. When "Shutdown after print finishes" is disabled the problem does not occur.
Versions:
Raspbian Debian 11
OctoPrint 1.9.3
Python 3.9.2
Automatic Shutdown 0.1.5
I have set the Abort Timeout to 900 seconds (15 min). Often I start a new print during that time. I start the print by sending it from OrcaSlicer without touching the OctoPrint interface.
It happened to me already 4 times now AutomaticShutdown did shutdown in the middle of such a second print, ruining the print.
It seems to me AutomaticShutdown is not correctly noticing a new print has been started. When "Shutdown after print finishes" is disabled the problem does not occur.
Versions:
Raspbian Debian 11
OctoPrint 1.9.3
Python 3.9.2
Automatic Shutdown 0.1.5