A part of the assignment for my project on FEBio (student version), require to create a calcified plaque into an artery. As far as the geometry is concerned, I should create a cylinder and a smaller concentric cylinder that represents the rigid plaque. In theory, I should first generate the mesh for each block and then join them using Merge Objects.
The question is: how can I achieve convergence while making sure that the meshes are correct in both parts and that they have been properly merged using the command? How do I adjust the meshes afterward—do I need to repeat the whole process again? I have never used the Merge Objects command before, but it was recommended to me, so I would like some further clarification about it if is possible.
A part of the assignment for my project on FEBio (student version), require to create a calcified plaque into an artery. As far as the geometry is concerned, I should create a cylinder and a smaller concentric cylinder that represents the rigid plaque. In theory, I should first generate the mesh for each block and then join them using Merge Objects.
The question is: how can I achieve convergence while making sure that the meshes are correct in both parts and that they have been properly merged using the command? How do I adjust the meshes afterward—do I need to repeat the whole process again? I have never used the Merge Objects command before, but it was recommended to me, so I would like some further clarification about it if is possible.