Jamulus not receiving input even though all routing is correct

[m-alawar]

Hi everyone, I’m having trouble getting my guitar signal into Jamulus and would appreciate any help.

My setup is:

Guitar > Kemper Main Out > Input 8 on Apogee Symphony MkII

The Symphony MkII is connected to my PC via Dante (Marian Clara E Card)

Routing is done in Dante Controller, where MKII inputs are correctly mapped to Clara-E inputs

To confirm this, I can firstly see the guitar signal coming into the Symphony MkII display. And, I can see signal coming through on the expected input channel over my DAW, so Dante routing seems to be working fine.

However, I'm not getting any signal coming through to Jamulus.

Settings:

Audio device: Clara-E (ASIO)
Input channels: 7–8
Sample rate: 48 kHz

I tried reinstalling Jamulus, restarting, closing all other apps, but no luck.

Appreciate any support - Thanks in advance!

[pljones]

Can you post screenshots, please.

[m-alawar]

Happy to help - can you be more specific on what you need screenshots of?

I basically run Jamulus but no signal comes through.

Jamulus settings are:
Audio device: Clara-E (ASIO)
Input channels: 7–8
Sample rate: 48 kHz

[pljones]

The Jamulus Settings Audio/Network tab.