Basic Settings

• FloorLayers
• RoofLayers
• LayerHeightMM
• Shells

FloorLayers

Default Value	Type	Units
2	Int	N/A

Controls the number of floor layers to be used. A value of zero means the infill pattern may be exposed on the downward-facing areas of the part.

Example

FloorLayers: 2	FloorLayers: 0

RoofLayers

Default Value	Type	Units
2	Int	N/A

Controls the number of roof layers to be used. A value of zero means the infill pattern may be exposed on the upward-facing areas of the part.

Example

RoofLayers: 2	RoofLayers: 0

LayerHeightMM

Default Value	Type	Units
0.3	Double	Millimeters

Controls the thickness of the layers. A lower value means a larger number of smaller, finer resolution layers that will capture more detail. A higher number means fewer but thicker layers, which will result in a coarser resolution but allow faster prints.

Example

LayerHeightMM: 0.3	LayerHeightMM: 0.6

Shells

Default Value	Type	Units
2	Int	Shells

Controls the number of exterior shells, also known as perimeters. Using more shells creates a thicker wall and will result in stronger parts. If set to 0, the sparse fill pattern will be exposed on the sides of the part.

Example

Shells: 1	Shells: 2